產品詳情
耐磨壓濾機泵@杭州耐磨壓濾機泵@耐磨壓濾機泵售后100%
Forming a sandwich type of angle layer, the sequence of the slow pre-increase pressure filtration, so that the residual free water in the mud layer to minimize, with the upper and lower two filter bands slowly forward, the upper and lower distance between the two filter bands gradually reduced, the middle of the mud gradually hardened, through the pre-pressure dehydration of large diameter filter rollers, For the mud cake to enter the extrusion dewatering zone smoothly, into the "S" press section, in the "S" type pressing section, the sludge is sandwiched in the middle and lower two layers of filter cloth, after several pressing rollers repeatedly pressed, the upper and lower two filter bands in the staggered rollers bed by the waveb path, due to the two filter bands in the upper and lower b order alternating, the clamping of the mud cake production, The most of the water remaining in the sludge is filtered out, bing the mud cake to dehydrate again, and finally through the scraper will dry mud cake scraping, by the belt conveyor or shaft-free spiral conveyor to the sludge storage. Plate and Frame filter press is the first to be used in chemical dehydration machinery. Although the plate and frame filter press is generally intermittent operation, infrastructure equipment investment is larger, filtration capacity is also low. However, due to its large filtration driving force, high solid rate of filter cake, b filter, high solid recovery rate, conditioning consumption and other advantages, in some small sewage plants are still widely used.
我公司生產的壓濾機入料泵是由我公司與江蘇理工大學流體機械研究所結合各壓濾機使用場合的入料工況，設計開發的壓濾機專用入料泵產品。jdhuiquan4.19
經過各種洗煤、環保、鋁廠、冶煉等場合，其性能已達到國內水平，一經投放市場，其壓濾效果、濾干時間、污水污物的防堵性、無泄漏及整機的穩定性均深受用戶好評。為各類用戶生產環節提益起到了積極的促進作用。
The undercurrent is used for the filtration of suspended fluids where the leachate is volatile or the filter is harmful to the human body. Filter press According to whether it is necessary to wash the filter slag, but also can be divided into two bs of washable and non-washable, can be washed called washable, otherwise known as non-washable. The filter plate of the washable filter press has two bs, the plate has a washing liquid inlet hole called the Perforated filter Plate (also known as the washing plate), the non-open detergent into the liquid hole of the said porous filter (also known as the not washing plate). The Washable filter press has one-way washing and two-way washing, one-way washing is placed alternaby by the combination of perforated filter plate and porous filter plate, and the bidirectional washing filter plate is a perforated filter plate, but the washing of two adjacent filter plates should be staggered and placed, and can not pass through the detergent at the same time. The filter press is used for the separation of solids and liquids. Compared with other solid-liquid separation equipment, the mud cake filtered by the filter press has higher solid rate and excellent separation effect. The basic principle of solid-liquid separation is that the mixture flows through the filter medium (filter cloth) and the solid stays on the filter cloth.
ZJW型壓濾機入料泵采用獨特的水力設計及葉輪安裝方式，確保了其性能曲線比一般雜質泵更陡，非常適合壓濾機入料時應阻力的變化來實現大流量，低壓力喂料與小流量，高壓力過濾的目的。其特殊的水力性能恰好吻合壓濾機由空腔到填滿再到濾干的漸進過程。喂料初期不用閥門控制流量過大引起的電機過載同時低壓力不會對濾板邊框產生沖擊，減輕了濾板邊框上的濾布的破損，也不會沖擊濾板造成震動，壓濾后期的小流量大壓力不易產生憋泵。尤其是在后期壓榨期時同泵在大壓力下其獨特的葉輪安裝方式及副葉輪的作用，保證軸封處的基本達到無泄漏。
耐磨壓濾機泵@杭州耐磨壓濾機泵@耐磨壓濾機泵售后100%
板框壓濾機的濾板整理不凈時,偶爾會造成介質外泄,一旦外泄,板框邊際就會被沖刷出一道一道的小溝來,介質的審察外泄造成壓力不能抬高,泥餅不能造成。對于經常操作板框壓濾機的工作人員來說，或多或少都會遇到很多意想不到的問題和事情，這些問題一旦得不到及時的解決，很可能會影響板框壓濾機的正常工作。明顯的特征就是，當板框壓濾機的濾布過濾時間有四個月左右時，濾布的滲透力就發生明顯的下降。以下三點能解決滲透力問題：清洗要經常進行清洗，這樣才能保證板框壓濾機的正常工作效率，雖說板框壓濾機本身帶有每周進行循環卸除濾餅的功能，但是因為濾布是長時間和過濾液接觸的，而且它們的工作環境是強壓力的，所以就會出現固體附著在濾布上的情況。
●性能參數：
|
型號 |
轉 速 (r/min) |
流 量 (m3/h) |
揚 程 (m) |
軸功率 (k/h） |
選配電機 功率(kw) |
|
65ZJW-III |
1480 |
27.5 41.4 55.2 69.0 80.0 |
76.0 72.2 66.1 56.0 43.5 |
22.3 |
Y225S-4 30KW |
|
Y225S-4 37KW |
|||||
|
80ZJW-III |
1480 |
40.0 60.0 80.0 100 115 |
76.0 72.2 66.1 56.0 43.5 |
32 |
Y225S-4 37KW |
|
Y225M-4 45KW |
|||||
|
100ZJW-III |
1480 |
56.0 85.0 113 150 169 |
73.3 69.0 62.5 51.2 44.0 |
49 |
Y225M-4 45KW |
|
Y250M-4 55KW |
|||||
|
125ZJW-III |
1480 |
70.0 105 140 186 245 |
73.5 71.6 68.6 61.9 48.5 |
62.5 |
Y250M-4 55KW |
|
Y280S-4 75KW |
|||||
|
125ZJW-III |
1480 |
79.7 119 159 211 279 |
80.0 78.0 74.8 67.5 52.9 |
78.2 |
Y280S-4 75KW |
|
Y280M-4 90KW |
|||||
|
125ZJW-III |
1480 |
58.0 87.0 116 154 203 |
91.8 89.1 85.7 77.3 60.6 |
64.7 |
Y280S-4 75KW |
|
Y280M-4 90KW |
Although the filtration machine filter cloth cost is not high, but the long-term accumulation is also an important expense. In addition, filter cloth in the usual storage should be placed in a boring environment, because the filter cloth is mostly fiber raw materials, inappropriate access simple bmorphosis, especially the impact of moist climate is more severe. Diaphragm filter press in order to make the filtered filter cake moisture content is the lowest, so through a series of improvements, the first is the change in the filter chamber. Diaphragm filter press to drop the water content of the filter cake is the filter cake implementation of two times kneading dehydration, so in the traditional box filter plate progress has been improved. Its filter plate is no longer the use of polypropylene composite data, but the selection of more pure, more flexible plastic raw materials, so that the raw material filter plate can be repeated through tens of thousands of times without cracking, debation. Also chose the appearance of the plane plan, do not want to be like the box filter plate to the internal depression, but the same appearance should also be blind spot, used to add filter plate and filter cake between the friction.
計量室，檢測用具完全，具有立車，鏜床，磨床等出產設備，河北會泉泵業以科技展開為方向，以質量處理為生命，以誠信運營為規律，以顧客滿意為意圖，秉承“謹慎務實。設有水泵功能測驗站河北會泉泵業有限公司技才能量雄厚開拓立異，忠實盡職，聯合，共創光輝”的企業精神，誠摯為廣大客戶供給優質的效力。
