產品詳情
高壓入料泵@洛陽高壓入料泵@高壓入料泵任你選
所有的污泥的漿泵主要是否有漏泥現象發生還有就是這些污泥泵的軸承以及盤根的密封。一般是在半個月就需要檢查一下。對液壓站的檢查，包括液壓液體的含量，液壓站的液體壓力系數。這是因為液壓站是隔膜壓濾機的重要動力部分，它的是否正常工作，關系到隔膜壓濾機過濾室的壓力，其更為重要的就是維持濾室的恒壓情況?？諝鈮嚎s機以及調速電機的觀油窗需要檢查，新設備在購買時已加好潤滑油，一般是在一個月的時間內再繼續檢查一下。通過檢查氣孔的閥門啟動來檢查控制這些氣體方面的內容，還有就是減壓閥的檢查。對濾板的檢查，廂式隔膜壓濾機的濾板初期，就可以看出濾板的好壞，檢查濾板的氧化情況；濾板在長期被水侵蝕的情況下，濾板的含水狀況，和被水侵蝕的深度。
我公司生產的壓濾機入料泵是由我公司與江蘇理工大學流體機械研究所結合各壓濾機使用場合的入料工況，設計開發的壓濾機專用入料泵產品。jdhuiquan4.19
經過各種洗煤、環保、鋁廠、冶煉等場合，其性能已達到國內水平，一經投放市場，其壓濾效果、濾干時間、污水污物的防堵性、無泄漏及整機的穩定性均深受用戶好評。為各類用戶生產環節提益起到了積極的促進作用。
Sludge filtration dehydration is driven by the pressure difference on both sides of the filter medium, so that the sludge moisture is forced to b the filter through the filtration medium, and the solid particles are intercepted on the medium to b a filter cake, so as to achieve the purpose of sludge dehydration. Sludge filter machine is a mechanical force on the side of the filter medium to achieve filtration machinery, mainly used for sludge (water) solid-liquid separation. Sludge filter machine is mostly used in papermaking, starch, alcohol, vitamin C Engineering and other industries of industrial sludge dewatering water sludge, through the sludge pump to the sludge mixing tank, while adding coagulant for full mixing reb, and then into the belt sludge pressure cloth mud, sludge evenly distributed to the gravity dewatering zone, and in the two-way channeling and gravity of the mud rake, With the movement of the Dewatering filter belt, the sludge quickly takes off the free water of the sludge. Due to the long design of gravity dewatering zone, maximum gravity dehydration is achieved. The flipped sludge enters the ultra-long wedge-shaped pre-pressure dewatering area to remove the sludge from the gravity zone slowly.
ZJW型壓濾機入料泵采用獨特的水力設計及葉輪安裝方式，確保了其性能曲線比一般雜質泵更陡，非常適合壓濾機入料時應阻力的變化來實現大流量，低壓力喂料與小流量，高壓力過濾的目的。其特殊的水力性能恰好吻合壓濾機由空腔到填滿再到濾干的漸進過程。喂料初期不用閥門控制流量過大引起的電機過載同時低壓力不會對濾板邊框產生沖擊，減輕了濾板邊框上的濾布的破損，也不會沖擊濾板造成震動，壓濾后期的小流量大壓力不易產生憋泵。尤其是在后期壓榨期時同泵在大壓力下其獨特的葉輪安裝方式及副葉輪的作用，保證軸封處的基本達到無泄漏。
高壓入料泵@洛陽高壓入料泵@高壓入料泵任你選
當板框壓濾機的壓力超過了濾板所能夠承受的壓力的時候，那么就會導致濾板炸裂的現象出現，這是非常危險的。通常液壓系統的不正常都是由于板框壓濾機壓力過高導致的，這樣會造成板框壓濾機液壓系統過熱，從而導致液壓油變質現象出現。板框壓濾機的壓力過高還會造成電動機過熱的現象出現，電動機過熱也會比較容易引發危險。可見，板框壓濾機工作壓力過高所帶來的危害還是很大的，為了保證壓濾機更加安全的操作，只有將其控制在合適的范圍之內，才可以減少故障問題的產生，延長板框壓濾機的使用壽命。板框壓濾機由壓濾機濾板、液壓體系、壓濾機框、濾板傳輸體系和電氣體系等五大部分組成.板框壓濾機勞動運轉的道理對照簡易,先由液壓施力壓緊板框組,沉淀的淤泥由中間進路,分散到各濾布之間.板框壓濾機的板框間滲水的辦理方式對照簡易,只要相應的增添液壓、調換濾布或許運用尼龍刮刀消除密封表面的塊狀物就能夠了。
●性能參數：
|
型號 |
轉 速 (r/min) |
流 量 (m3/h) |
揚 程 (m) |
軸功率 (k/h） |
選配電機 功率(kw) |
|
65ZJW-III |
1480 |
27.5 41.4 55.2 69.0 80.0 |
76.0 72.2 66.1 56.0 43.5 |
22.3 |
Y225S-4 30KW |
|
Y225S-4 37KW |
|||||
|
80ZJW-III |
1480 |
40.0 60.0 80.0 100 115 |
76.0 72.2 66.1 56.0 43.5 |
32 |
Y225S-4 37KW |
|
Y225M-4 45KW |
|||||
|
100ZJW-III |
1480 |
56.0 85.0 113 150 169 |
73.3 69.0 62.5 51.2 44.0 |
49 |
Y225M-4 45KW |
|
Y250M-4 55KW |
|||||
|
125ZJW-III |
1480 |
70.0 105 140 186 245 |
73.5 71.6 68.6 61.9 48.5 |
62.5 |
Y250M-4 55KW |
|
Y280S-4 75KW |
|||||
|
125ZJW-III |
1480 |
79.7 119 159 211 279 |
80.0 78.0 74.8 67.5 52.9 |
78.2 |
Y280S-4 75KW |
|
Y280M-4 90KW |
|||||
|
125ZJW-III |
1480 |
58.0 87.0 116 154 203 |
91.8 89.1 85.7 77.3 60.6 |
64.7 |
Y280S-4 75KW |
|
Y280M-4 90KW |
Hydraulic compb is a hydraulic station through the rack of the hydraulic cylinder components to promote the compb plate compression. The two beams connect the thrust plate and the compb device together to b the rack, the press on the rack and the clamping device are connected, and the filter plate and the filter frame are arranged alternaby between the thrust plate and the clamping plate, and the filter medium is clamped between the filter plate and the filter frame, and the compb device pushes the clamping plate, presses all the filter plates and the filter frame in the rack, and after reaching the rated compb force, Can be filtered. Suspension from the feed hole on the thrust plate into the filter chamber (filter frame and adjacent filter plate to b the filter chamber), solid particles are filtered by the filter medium in the filter room, the filter through the medium, from the liquid hole out of the machine. The liquid of the filter press has two bs, the b flow and the undercurrent, filter from each filter plate out of the liquid hole directly discharged from the machine outside the call flow, the b flow type is convenient for each filter plate filtration situation, found that a filter plate filter is not pure, you can close the plate out of the liquid mouth; If the filter of the filters converge from an outlet pipe out of the machine, it is called the undercurrent type.
歡迎各界朋友蒞臨賞識，經歷和事務洽談。 收起河北會泉泵業有限公司的誠信，實力和產質量量取得業界的認可。歡迎各界朋友蒞臨賞識，經歷和事務洽談。
